MTU 20 V 4000 C22 Operations Instructions Page 36
- Page / 144
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
4.7 Cleaning the plant
Preconditions
☑Engine shut down and secured against being restarted.
☑Power supply not connected.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
Steam jet cleaner
- 1
Cleaning agent (Hakupur 312)
30390 1
WARNING
Compressed air gun ejects a jet of pressurized air.
Risk of injury to eyes and damage to hearing, risk of rupturing internal organs.
• Never direct air jet at people.
• Always wear safety goggles/face mask and ear defenders.
WARNING
Steam jet cleaner ejects jet of pressurized water.
Risk of injury to eyes and scalding.
• Never direct water jet at people.
• Wear protective clothing, protective gloves and safety goggles/face mask.
NOTICE
Cleaning agents should not be left to take effect for too long.
Damage to components is possible.
• Observe manufacturer's instructions.
NOTICE
Blowing down product with compressed air
Entry of dirt and damage to components is possible.
• Do not aim compressed air gun directly at seals or electronic components such as connectors
or ECUs.
Cleaning the system
1. Carry out system cleaning only in areas where an appropriate oil separator is provided (environmental
protection).
2. Before starting to use the pressure/steam jet washer, read the Operating Instructions for the appliance
observe the safety precautions.
3. If cleaning the outside of the system with a pressure/steam jet washer:
• The pressure of the high-pressure jet (cleaning jet) must not exceed 50 bar.
• A minimum distance between spray nozzle and system of 1 m must be observed.
• The temperature of the cleaning agent must not exceed 80 °C.
4. For external cleaning with high-pressure jet, use a flat-mouth nozzle only.
5. Carry out external cleaning as follows:
a) Seal all openings in a suitable fashion.
b) Remove coarse dirt.
c) Spray on cleaner sparingly and leave it for 1 to 5 minutes.
d) Use the high-pressure jet to remove the loosened dirt.
Note: Never aim compressed air directly at electronic components.
e) Dry engine.
36 | Operation |
M015675/06E 2013-04
TIM-ID: 0000010171 - 026
- Operating Instructions 1
- Table of Contents 3
- 1 Safety 5
- Personnel requirements 6
- 1.3 Transport 7
- Transport 8
- TIM-ID: 0000004012 - 001 9
- Operation 10
- TIM-ID: 0000040535 - 001 11
- Welding work 12
- Working with batteries 12
- Fire prevention 14
- Used oil 14
- Safety notices 16
- 2 General Information 17
- 2.2 Engine layout 18
- TIM-ID: 0000002072 - 002 19
- Engine model designation 20
- TIM-ID: 0000012921 - 003 21
- COMBUSTION AIR / EXHAUST GAS 25
- COOLING SYSTEM (HT circuit) 25
- COOLING SYSTEM (LT circuit) 25
- LUBE OIL SYSTEM 25
- FUEL SYSTEM 26
- GENERAL OPERATING DATA 26
- CAPACITIES 26
- WEIGHTS / MAIN DIMENSIONS 26
- ACOUSTICS 27
- 3.2 Firing order 28
- 3.3 Main engine dimensions 29
- 4 Operation 30
- Preparation 32
- Start engine 32
- 4.4 Operational checks 33
- Stop engine 34
- 4.7 Cleaning the plant 36
- 5 Maintenance 37
- 6 Troubleshooting 38
- TIM-ID: 0000002541 - 002 39
- Component Cause Action 40
- 6.2 ECU 4 alarms 41
- TIM-ID: 0000003161 - 001 42
- 7 Task Description 52
- Barring engine manually (tool 53
- TIM-ID: 0000000950 - 003 54
- TIM-ID: 0000003285 - 003 57
- 7.3 Crankcase Breather 59
- Checking diaphragm 60
- Clean crankcase breather 61
- Clean filter element 62
- TIM-ID: 0000003532 - 003 64
- Installing grounding device 66
- Replace carbon brush 67
- 7.5 Valve Drive 68
- Checking valve-bridge balance 70
- TIM-ID: 0000004355 - 001 71
- Adjusting valve clearance 73
- Removing cylinder head cover 74
- 7.6 Injection Pump / HP Pump 75
- HP pump – Relief bore check 76
- 7.7.1 Injector – Replacement 77
- Remove injector 79
- Install injector 80
- TIM-ID: 0000000952 - 010 81
- 7.8 Fuel System 83
- 7.9 Fuel Filter 84
- 7.9.2 Draining fuel prefilter 85
- 7.10 Charge-Air Cooling 88
- 7.11 Air Filter 89
- Checking signal ring position 92
- 7.12 Starting Equipment 93
- TIM-ID: 0000006161 - 004 94
- 7.14 Oil Filtration / Cooling 96
- TIM-ID: 0000006401 - 006 97
- Removing strainer 99
- Checking strainer 100
- Cleaning strainer 100
- Installing strainer 100
- Preconditions 101
- TIM-ID: 0000000934 - 012 102
- Engine coolant change 104
- Engine coolant – Draining 105
- Preparatory steps 105
- Filling with coolant using a 107
- Final steps 107
- TIM-ID: 0000000961 - 010 108
- 7.16 Low-Temperature Circuit 111
- Charge-air coolant – Change 112
- Charge-air coolant – Draining 113
- Charge-air coolant pump – 116
- Checking pressure relief port 116
- Engine mounting – Check 117
- 7.18 Belt Drive 118
- 7.19.3 Generator – Cleaning 121
- Adjusting belt tension 122
- Checking drive belt tension 123
- – Drive belt replacement 124
- 7.20 Fan Drive 125
- Adjusting drive belt tension 126
- Replacing drive belt 127
- 7.21.1 Engine wiring – Check 128
- TIM-ID: 0000000948 - 011 129
- Checking engine control unit 130
- 8 Appendix A 131
- TIM-ID: 0000000858 - 011 132
- Local support 134
- 24h hotline 134
- Spare parts service 134
- 9 Appendix B 135
- DCL-ID: 0000014250 - 002 136
Related products and manuals for Engine MTU 20 V 4000 C22
Engine MTU 12 V 2000 M94 Operations Instructions
(141 pages)
(141 pages)
Engine MTU 16 V 2000 S96 Operations Instructions
(133 pages)
(133 pages)
Engine MTU 12 V 2000 M72 Operations Instructions
(147 pages)
(147 pages)
Engine MTU 20 V 4000 G23 Operations Instructions
(181 pages)
(181 pages)
Engine MTU C23R Operations Instructions
(163 pages)
(163 pages)
Engine MTU 8 V 2000 M40B Operations Instructions
(204 pages)
(204 pages)
Engine MTU 20 V 4000 C22 Operations Instructions
(139 pages)
(139 pages)
Engine MTU 12 V 2000 P12 User Manual
(190 pages)
(190 pages)
Engine MTU 12 V 4000 C10R User Manual
(124 pages)
(124 pages)
Engine MTU 12 V 2000 P12 Operations Instructions
(187 pages)
(187 pages)
Engine MTU 12 V 4000 C10R Service Manual
(104 pages)
Engine MTU 12V 2000 C66 Operations Instructions
(136 pages)
(136 pages)
Engine MTU 16 V 2000 P12 Specifications
(216 pages)
(216 pages)
Engine MTU Gas engine8 V 4000 L62 Specifications
(104 pages)
(104 pages)
Engine MTU 12 V 4000 C21 Service Manual
(214 pages)
(214 pages)
Engine MTU 20 V 4000 M93 Operations Instructions
(193 pages)
(193 pages)
Engine MTU Gas engine8 V 4000 L62 User Manual
(169 pages)
(169 pages)
Engine MTU C23 User Manual
(12 pages)
(12 pages)
Engine MTU 12 V 4000 L62 Operations Instructions
(187 pages)
(187 pages)
© 2020, manymanuals.com. All rights reserved. | 1.346 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals